Pressing Instructions

How to apply your Wolf + Aster DTF Transfer

1. Position Transfer
   Align Carefully
   Place the transfer in the desired position. Pre-press is not required, if you do wait for it to cool.
   
   

2. Apply Heat
   6-12 sec | 157C - 163C             (315F - 325F)

   Press with firm, even pressure to bond the transfer to the fabric.
   

    

3. Peel + Reveal
   Do not show the DTF fear. It can sense it.

   Peel while warm, starting from one corner. Cold peel can be done, but can be more difficult.

4. Final Press
   6-12 sec

   Cover the design again (parchment or Teflon) and press to seal the design into the fabric.

 

Pro Tips for Best Results

• Surface Matters
  Ensure your pressing area is completely flat. Avoid seams, collars, or buttons. Use a pressing pillow if needed to raise the print area.
• Pick Your Finish
  Matte Finish: Use Parchment Paper or Kraft Paper.
  Glossy Finish: Use a Teflon Sheet.
• Technique
  Roll the film back over itself rather than lifting it straight up. Start peeling from the boldest part of the design, not fine lines. 
• Avoid Creasing
  After the final press, lay the garment flat and allow it to cool completely before folding to prevent permanent creases.